Boob armor pattern - Athena Saint Seiya

This is the pattern for the bra I made for my Athena - Saint Seiya costume. I noticed that without the ornaments on top, this could easily pass as any chest piece for an armor, so I decided to scan and upload it, maybe it's useful for somebody.

THIS IS AN A3 SIZE DOCUMENT, SO IT CAN BE ACTUALLY PRINTED TO THE SIZE THAT I USED, WITHOUT HAVING TO SCALE IT! I am not sure what sizes of paper are used all over the world, but an A3 is 42 cm x 29.7cm.

This is only for one half, the other one being just a mirrored version of this one. The main four parts of this pattern are named BRA 1, 2, 3 and 4. When glued together, they resemble a lot the roundness of any bra on the market. Also, I must say that I am quite busty, and if you make this out of any rather hard material (craft foam or wonderflex), you can create the impression that your bust is larger. The bra sides A and B (that come glued together) must also be glued to the areas where there are the two arrows. These actually can be longer and can continue towards the back, but I needed them short, because I had wings on my back and they took a lot of space.

Then come the ornaments. I coloured on the BRA 1, 2, 3 and 4 parts where each part goes where, to make things easy. The ornaments in the middle are A and B and then there are 1, 2, 3 and 4, that come on the sides. The spot where no 3 is is where you have the middle of the chest, the place where you must glue the two parts together.

This is how my bra turned out, btw, for those who don't know: [link]